• Installation & Setup
• Whole-home standby generator installation
• Automatic transfer switch installation
• Generator replacement & upgrades
• Load calculations & sizing
• Permit handling & code compliance
• Gas coordination (with plumber or utility)

Repairs & Troubleshooting

• Generator not starting

• Generator runs but no power

• Transfer switch failure

• Battery charging issues

• Alarm and fault code troubleshooting

• Control board diagnostic

Warranty and Generac Specific Services

Generac warranty inspections

Warranty repair coordination

Startup commissioning (required for warranty)

Post-install system verification

Documentation for Generac registration

Backup Generator Services

Annual generator maintenance

Semi-annual maintenance plans

Preventative maintenance inspections

Scheduled service contracts

Pre-storm readiness inspections

Oil & Fluid Services

Generator oil change

Oil filter replacement

Air filter replacement

Spark plug replacement

Coolant level check (liquid-cooled units)

Battery inspection & replacement

Testing & Performance

Load bank testing

Automatic exercise cycle verification

Transfer switch testing

Voltage & frequency testing

System diagnostics & error code checks

Repairs & Troubleshooting

Generator not starting

Generator runs but no power

Transfer switch failure

Battery charging issues

Alarm and fault code troubleshooting

Control board diagnostic

Warranty and Generac Specific Services

Generac warranty inspections

Warranty repair coordination

Startup commissioning (required for warranty)

Post-install system verification

Documentation for Generac registration